12/22/2023 0 Comments Nuvoton ice driver![]() USB interfaces: MSC/VCOM/HID_ICE(proprietary commands) or CMSIS-DAPv2 WinUSB + WebUSB CMSIS-DAP/VCOM_Nu-Link2-Bridge or HID_ISP (defined by BRIDGE-MODE of NU_CFG.Support NuMicro 8051, offline programming, user code read-out protection, unlimited flash break points, NuMicro chips specific features (config0/config1 dataflash setting, KPROM, etc.).Set CMSIS-DAP=0, it will disable CMSIS-DAP and enable Nu-Link2 "USB BULK_ICE" interface (it's faster than "USB HID_ICE").Ĭomparison of NuLink2FW.bin and NuLink2_DAPLink.bin NuLink2FW.bin.It has a WebUSB interface conform CMSIS-DAP protocol, and you can connect KEIL Studio via this interface. Update drivers with the largest database available. Set CMSIS-DAP=1, this is default setting. Get the latest official Matrox G200eW (Nuvoton) display adapter drivers for Windows 11, 10, 8.1, 8, 7, Vista, XP PCs.If you use Nu-Link2-ME, it doesn't support BRIDGE functions, you will only see CMSIS-DAP option.This USB HID interface doesn't pass through data, it communicates with ISPTool via HID_ISP, and offers I2C/SPI/RS485/CAN interfaces for ISPTool. Set BRIDGE-MODE=2, an USB HID interface supports ISPTool will be enabled. The 24 MHz dummy clock, that is currently in the devicetree, is no longer needed. automatically based on the clock tree as it was preconfigured by the bootloader. This means that the clock rates for peripherals will be calculated. (You will see a "Nu-Link2-Bridge Virtual Com Port" in device manager.) This series adds support for the clock and reset controller in the Nuvoton. Nu-Link2-Bridge pass-through the data between VCOM port and I2C/SPI/RS485/CAN interfaces. Set BRIDGE-MODE=1, the pass-through bridge function of Nu-Link2-Pro will be enabled (The word Nu-Link2-Bridge will be used to represent the pass-through bridge application on Nu-Link2-Pro adapter). Note that CMSIS-DAP will be disable in other BRIDGE-MODE (Limited USB endpoints). Set BRIDGE-MODE=0, this is default setting. Set POWER-MODE for SWD output voltage level (mainly for CMSIS-DAP interface use) Windows 10 Fall Creators Update and Later Servicing Drivers, Windows 10 S Version 1709 and Later Servicing Drivers for testing. For Nu-Link2-Pro, you will see POWER-MODE, BRIDGE-MODE options, you need re-plug in USB cable to effect the setting. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |